Dog Trainer Ultrasonic Outdoor Animal Repellent Motion Sensor Three-In-One Flash LED Dog Cat Animal Repellent
Description: Repel dogs and cats: Press the laser butter on the top of the side, point directly at the dog or cat, and then press the "Start" button for a few seconds. Ultrasonic waves should prevent the welding torch from approaching. If necessary, press the "Start" button for a longer time. Please note that the main working range can be up to 80 meters. The Sonic Laser Animal Chaser will discourage most cats and dogs, but it may not be effective in all situations because some older animals may be hearing impaired. Use caution when approaching animals, and be careful not to surprise them.
specification
Power supply: 1X9V battery (not included) Output: 9V DC Working current: less than 100ma Effective range: up to 80 meters Ultrasonic frequency: 25KHz
Battery placement
Always use 9 volt alkaline batteries, unless you use alkaline batteries, your device will not work. 1. Slide the battery compartment cover away from the unit, 2. Connect the 9 volt alkaline battery to the correct terminal and plug the battery compartment cover back onto the device. 3. When you press the "Start" button, if the red light on the top is on and stays on, it means that the machine is working normally. If the red light is off, please replace the battery.
Tips
1. Do not touch the front shielding area. Depression or damage in this area may cause malfunction of the unit. 2. Do not use it on other animals, or it is not recommended to use it for any purpose. 3. Do not use within one foot of humans or pets. 4. Be extra careful when handling potentially dangerous animals. 5. Keep Sonic laser animal chaser away from children. 6. Do not aim the laser directly at the eyes, otherwise it will seriously damage the eyes.