Wireless fence system KD661 easy Set-up
1.Power on transmitter or receiver collar
Press the Power button and hold 3 seconds to make sure transmitter or receiver collar turn on.
2.Pair the transmitter with receiver collar
Turn on the transmitter and press the power button shortly. It will display “1dp” and flashes, which indicates the transmitter is in status of pairing
Then, power on the receiver collar and press the power button shortly, it will receive the pairing signal from transmitter and start pairing, When the receiver issued a single sound of “Bi” and blue LED flashes once, the transmitter is pairing is successfully with THIS receiver collar.
Notice: You must press the transmitter and receiver collar SHORTLY, to make it in pairing status. Once you press and hold the power button for 3 seconds, the device will turn OFF.
3.Set up the remote control range
The remote control range is a straight distance between transmitter and receiver collar. For this wireless fence KD661,the max. distance is up to 500 meters. To set up the proper distance, you can adjust the power level of transmission signal.
Press button”+” or”-” on the transmitter, you can increase or decrease the power level from O to 100 degrees. the value you are setting will display on the screen.
Power Level - Remote Control Distance
10 - 25m
20 - 50m
30 - 65m
40 - 80m
50 - 95m
60 - 115m
70 - 140m
80 - 170m
90 - 230m
100 - 500m
Below table is correspondence between power level of transmission signal and remote control distance. Please set the proper power level according to the control distance you want.
4.Verify the function of wireless fence system
To validate the fence system and remote control distance. Please follow as below steps:
1.Power on the transmitter and set the power level to 10,
2.Turn on the receive collar and take away from transmitter. It will release warning sounds “Bi-Bi”, while the receiver is about 20 meters far way.
3.After 3 times warning sound, it will change to static shock mode automatically. Take away the receiver and place the test LED on the contact probes of receiver, the LED will turn on. lf the receiver collar is kept away, the shock intensity will be gradually increasing. As result, the LED will be brighter gradually.
5.Put the transmitter in right place
To avoid transmission signal strength and remote distance affected by the surrounding environment, please place the transmitter l.5 meter above the ground, and make sure there is no any metal wall around it.
6.lmportant Notice:
During the system is running smoothly, the transmitter has been powered off somehow, the receivyer will automatically start up warning sound and then static stimulation, which is similar that the receiver is beyond the setting range.
Reset Operation
1.Reset Transmitter: if the battery is full capacity, but the transmitter can't power on, please press the RESET button to restart it. Then it will be powered on.
2.Reset Receiver: when the batter is full capacity, but the receiver collar can't power on, please charge the receiver collar again for one or two seconds to make it RESET. Then it will be powered on.